Long-lasting protective coating for glass surfaces
Creates a water repellent layer
Protects against salt, calcium, and other mineral deposits
Glass coverage up to 2,500 sq. ft.
Appearance: Clear liquid
Solubility: 100% in water
pH: (N/A)
Always wear clean nitrile gloves!
Do not apply in direct sunlight or to a hot glass surface!
Clean the prepared glass surface with CRYSTAL CLEAR to remove the G200 residue and other contaminants.
Repeat the last step three times. The glass surface must be completely clean.
Apply GLASSTEC to the microfiber applicator pad (not to the point that it is dripping).
Apply all around the perimeter of the glass surface. Do not work in sections larger than 2 square feet at a time.
Apply GLASSTEC in overlapping circles over the entire glass surface. Make certain that an adequate amount of GLASSTEC is kept on the microfiber cloth.
Apply again using a cross hatch (up and down, then sided to side pattern).
Allow GLASSTEC to dry for 2 minutes, then buff off any residue with a clean microfiber cloth.
GLASSTEC consumption should be 2-3 ml per square foot of glass surface.
MARPOL Annex III and Annex V Compliant
NPDES Compliant
REACH Compliant
No VOC’s, non-fuming, non-corrosive to skin
Loading...
Total items
Product subtotal
